4 square purple beads (or color of your choosing)
2 earring hooks
2 small jump rings (not shown)
needle nose pliers
|Step 1: Place each headpin through each square bead. Cut the|
wire approximately 1/4 inch from the top of the bead and fold
to the side.
|Step 2: Holding the bent wire with your needle nose plyers,|
wrap the wire into a loop around the plyers.
|Step 3: Trim Excess wire.|
|Step 4: Repeat Step 2 for all 4 beads.|
|Step 5: Cut chain into 2 lengths, depending on your|
preference. 2 shorter and 2 longer.
|Step 6: Attach each piece of chain to a bead.|
|Step 7: Close the loops over the chain with needlenose|
|Step 8: Open Earring hooks and jump rings with needlenose|
|Step 9: Attach 1 small and 1 large chain to a jump ring.|
Close jump ring with needlenose plyers. Repeat with remaining
two chains and jump ring.
|Step 10: Place jump rings on open earring hooks, making sure|
both earrings are facing the same way. (Pictured above, each
earring has the small chain on the left and long chain on the
|Step 11: Close Earring Hooks|
PS – I party here!
Powered by Yahoo! Answers